Table of Contents
Advertisement
SwitchBlade x8112 Chassis Switch and AT-SBx81CFC400 Card Installation Guide
Release Tab
Figure 104. Sliding the AT-QSFPCU Cable into the Slot
3. Install the other end of the cable into a compatible QSFP+ slot on
another network device.
4. Repeat this procedure to install additional AT-QSFPCU Cables.
Note
To remove the connector and cable from the slot, gently push on the
connector, pull on the release tab, and slide the connector from the
slot.
5. After installing the AT-QSFPCU Cables, do one of the following:
To install and cable additional transceivers, go to the appropriate
section in this chapter for instructions.
After cabling all the ports in the chassis, go to Chapter 9,
"Powering On the Chassis" on page 173.
167
Advertisement
Table of Contents
