Figure 163: Disconnecting The Expansion Module From The At-Sbx81Xlem Line Card - Allied Telesis AT-SBx81CFC400 Installation Manual

SwitchBlade x8112 Chassis Switch and AT-SBx81CFC400 Card Installation Guide
5. Lift the front of the line card and carefully insert the tip of a flathead
screwdriver into the slot on the bottom panel of the expansion module.
Gently twist the screwdriver to disconnect the module from the
connector in the line card. Refer to Figure 163.
Figure 163. Disconnecting the Expansion Module from the AT-
6. Slide the expansion module from the line card. Refer to Figure 164 on
page 258.
SBx81XLEM Line Card
257