Table of Contents
Advertisement
Chapter 8: Installing Transceivers and Cabling the Ports
Installing AT-QSFPSR, AT-QSFPSR4, or AT-QSFPLR4 Transceivers
168
This section contains the procedure for installing AT-QSFPSR, AT-
QSFPSR4, or AT-QSFPLR4 transceivers in the slots on the AT-
SBx81XLEM/Q2 Expansion Module.
Note
The AT-QSFPSR, AT-QSFPSR4, and AT-QSFPLR4 transceivers
are only supported in the AT-SBx81XLEM/Q2 Expansion Module.
Note
The AT-SBx81XLEM/Q2 Module supports revision B of the AT-
QSFPSR4 transceiver. It does not support revision A. The revision
level of the transceiver is printed on the transceiver label, after the
serial number. You can also display it with the SHOW SYSTEM
PLUGGABLE DETAIL command in the AlliedWare Plus operating
system.
Please review "Guidelines to Installing SFP, SFP+, or QSFP+
Transceivers" on page 157 before performing this procedure.
To install AT-QSFPSR, AT-QSFPSR4, or AT-QSFPLR4 transceivers,
perform the following procedure:
1. Remove the dust cover from a slot on the AT-SBx81XLEM/Q2
Expansion Module. Refer to Figure 103 on page 166.
2. Slide a transceiver into the slot until it clicks into place.
3. Attach a fiber optic cable to the transceiver.
4. Repeat steps 1 to 3 to install and cable transceivers in the other slots
of the expansion module.
5. Connect the cables to compatible QSFP ports in other network
devices.
Note
To remove the connector and cable from the slot, gently push on the
connector, pull on the release tab, and slide the connector from the
slot.
6. After installing the transceivers, do one of the following:
To install and cable additional transceivers, go to the appropriate
Advertisement
Table of Contents
