10.6
Parameter Setting
Set the communication parameters of the master module, NZ2FT-PBV, and I/O module from the software package of the
master module.
RJ71PB91V and QJ71PB92V setting
Start PROFIBUS Configuration Tool or GX Configurator-DP and configure the PROFIBUS-DP communication settings and
the parameter settings of the NZ2FT-PBV and I/O module. For details, refer to the following.
• When the master module is the RJ71PB91V: DP-Master parameter setting ( MELSEC iQ-R PROFIBUS-DP Module
User's Manual (Application))
• When the master module is the QJ71PB92V: Master parameter, bus parameter ( PROFIBUS-DP Interface Module
User's Manual (Details))
Setting item
The following describes the operation where PROFIBUS Configuration Tool is used in the RJ71PB91V.
■Adding the GSD file
Add the GSD file to PROFIBUS Configuration Tool. ( Page 226 GSD file)
[Import Tasks] [Add GSD File]
The NZ2FT-PBV information is added to "Global GSD Database" by adding the GSD file.
■FDL address of the DP-Master
Set the FDL address of the DP-Master on the "Master Settings" window.
[PROFIBUS Network] Right-click the master module [Master Settings]
Set the FDL address of the DP-Master for "FDL address".
10 NZ2FT-PBV
238
10.6 Parameter Setting