Terms - Mitsubishi Electric NZ2FTGN User Manual

TERMS

Unless otherwise specified, this manual uses the following terms.
Term
Buffer memory
CC-Link
CC-Link IE TSN
Cyclic transmission
Dedicated instruction
Device
EtherNet/IP Configuration Tool for
RJ71EIP91
GX Configurator-DP
GX Configurator-PN
GX Works2
GX Works3
Master station
Process data
PROFIBUS Configuration Tool
Profiles
PROFINET
Remote station
SLMP
SNMP
Status word
Transient transmission
22
Description
A memory in an intelligent function module, where data (such as setting values and monitoring values) exchanged with
a CPU module are stored
A high-speed field network that can handle control and information at the same time
An integrated network that includes the CC-Link IE Field Network and SSCNET III/H Network
A function by which data are periodically exchanged among stations on the network
An instruction that simplifies programming for using functions of intelligent function modules
A memory of a CPU module to store data. Devices such as X, Y, M, D, and others are provided depending on the
intended use.
It is a tool used to set the EtherNet/IP network configuration.
A tool to set PROFIBUS-DP communication parameters and slave parameters of the MELSEC-Q series and write them
to the master station
A tool to set PROFINET communication parameters and slave parameters and write them to the master
The product name of the software package for the MELSEC programmable controllers
A station that manages the entire network.
Cyclic transmission send ranges for each station are assigned in the only one master station in a network.
This station can perform cyclic transmission and transient transmission with all stations.
Process data. An area that stores I/O data of the I/O module,
A tool to set PROFIBUS-DP communication parameters and slave parameters of the MELSEC iQ-R series and write
them to the master station
A file such as module or device identification information. If necessary, register it in GX Works3 or GX Works2, and
enable parameter settings and monitors according to the registered module or device.
An industrial Ethernet protocol offered by PROFIBUS & PROFINET International
A station that performs cyclic transmission in units of bits and words with the master station in the CC-Link IE TSN
network. This station can perform transient transmission.
SeamLess Message Protocol. A protocol that enables seamless communication between Ethernet and CC-Link and
CC-Link IE networks.
Simple Network Management Protocol. A protocol for network monitoring and network management.
Status information. Stores the operating status of the coupler.
Communications excluding the cyclic transmission. A function by which data are non-periodically exchanged among
nodes (stations) on the network