Chapter 7 Nz2Ft-Gn; Cc-Link Ie Tsn Configuration; Corresponding Master Module And Software Package; Profiles - Mitsubishi Electric NZ2FTGN User Manual

7
NZ2FT-GN
This chapter describes the details of the CC-Link IE TSN compatible coupler.
7.1

CC-Link IE TSN Configuration

The NZ2FT system using the NZ2FT-GN operates as a remote station for CC-Link IE TSN.
It uses an Ethernet cable and hub. ( Page 41 Wiring products for coupler that use the Ethernet cable)
When the master module is the RJ71GN11-T2
It consists of a master station (1), an inverter device (2), a remote station (3), and an Ethernet device (4). (System
configuration  MELSEC iQ-R CC-Link IE TSN User's Manual (Startup))
(4)
(3)

Corresponding master module and software package

The master module corresponding to the NZ2FT-GN and the software package corresponding to the master module are
shown.
For how to check the version, refer to the manual for each master module and software package.
Master module
Name
CC-Link IE TSN master/local module

Profiles

The profile for setting the NZ2FT-GN and I/O module must be registered in the software package. For information on how to
obtain the profile, contact your local Mitsubishi representative.
Registration Name
destination
software
package
GX Works3 CC-Link IE TSN profile for the NZ2FT-GN
(CSP + file)
CC-Link IE TSN profile for the I/O module
(CSP + file)
7 NZ2FT-GN
96
7.1 CC-Link IE TSN Configuration
(3)
Model Firmware version
RJ71GN11-T2 "12" or later
Release file name
0x0000_NZ2FT-GN_[Device version]_[Language].CSPP.zip
([Device version]: 0001 to 9999, [Language]: en)
0x0000_[Model name]_[Device
version]_[Language]_CCLinkIETSN.CSPP.zip
([Model name]: Model name of I/O module, [Device version]: 0001 to
9999, [Language]: en)
(1)
(2)
Software package
Product
name
GX Works3
Version
1.070Y or later
Version
00 or later
00 or later