Part Names - Mitsubishi Electric NZ2FTGN User Manual

9.2

Part Names

This section describes the LEDs of the NZ2FT-PN. ( Page 94 Coupler Common Part Names)
(1)(2)(3)(4)(5)(6)(7)(8)
(9)
(10)
No. Name
(1) PW LED
(2) SF LED
(3) BF LED
(4) MT LED
(5) LINK1 LED
(6) ACT1 LED
(7) LINK2 LED
(8) ACT2 LED
(9) P1 (Ethernet port)
(10) P2 (Ethernet port)
Description
Indicates the status of the module power supply.
On in green: Power-on
Off: Power-off
Indicates the module status.
On in red: Error ( Page 220 When the SF LED turns on in red)
Flashing in red: Force mode
Off: No error
Indicates a communication error.
On in red: Fieldbus error ( Page 221 When the BF LED turns on in red)
Flashing in red: Error ( Page 221 When the BF LED is flashing in red)
Off: No error
Shows the status of the NZ2FT-PN and I/O modules.
On in yellow: Error ( Page 221 When the MT LED turns on in yellow)
Off: No error
Indicates the connection status of the fieldbus. It does not light on on the Web server window.
On in green: Connection is established between P1 of the NZ2FT-PN and other field devices.
Off: Connection is not established between P1 of the NZ2FT-PN and other field devices.
Indicates the operating status of the fieldbus.
Flashing in yellow: Data is being exchanged at P1. (The flashing speed changes depending on the frequency of
transmission and reception.)
Off: Connection is not established between P1 of the NZ2FT-PN and other field devices.
Same as LINK1 LED
Same as ACT1 LED
Connect an Ethernet cable. ( Page 41 Wiring products for coupler that use the Ethernet cable)
9
9 NZ2FT-PN
169
9.2 Part Names