Ip Address Setting Switch - Mitsubishi Electric NZ2FTGN User Manual

No. Name
(9) USB port and IP address
setting switch cover
(10) P1 (Ethernet port)
P2 (Ethernet port)

IP address setting switch

On the NZ2FT-GN, the IP address setting switch on the front of the module is used to set the 4th octet of the IP address. (For
the 1st to 3rd octets, use the 1st to 3rd octets of the IP address of the master station.)
It is an 8-digit binary number, and the setting range is 1 to 254.
• If 0 is set, the IP address recorded in the non-volatile memory of the NZ2FT-GN (set value of parameter "IP address") will
be used.
• If 255 is set, error code 0106H will occur and data link will not be performed with the master station. ( Page 129 Error
code)
The setting is enabled when the power is turned on, so turn off the power of the NZ2FT-GN when setting.
Ex.
Fourth octet of IP address 173: 10101101 (binary)
ON
The IP address setting switches "8" to "1" correspond to the most significant digit (b7) to the least significant
digit (b0) of the binary of the 4th octet of the IP address in order from the top.
Precautions
Depending on the IP address status, the LED of the NZ2FT-GN will be as follows.
• ERR. LED is on in red: An IP address that is out of range is set.
• ERR. LED is flashing in red: The IP address changed during operation. When the IP address setting switch is restored, the
LED indication before the change is restored.
7 NZ2FT-GN
98
7.2 Part Names
Description
A cover for the USB port and IP address setting switch
• USB port: To use the Web server, open this cover and connect a USB cable.
• IP address setting switch: Set the fourth octet of the IP address. ( Page 98 IP address setting switch)
When not in use, close this cover to prevent entrance of foreign material such as dust.
Connect an Ethernet cable. ( Page 41 Wiring products for coupler that use the Ethernet cable)