Part Names - Mitsubishi Electric NZ2FTGN User Manual

12.2

Part Names

This section describes the LEDs of the NZ2FT-EIP. ( Page 94 Coupler Common Part Names)
(9)
(10)
No. Name
(1) PW LED
(2) SF LED
(3) BF LED
(4) MT LED
(5) L/A P1 LED
(6) L/A P2 LED
(7) MS LED
12 NZ2FT-EIP
364
12.2 Part Names
(1)(2)(3)(4)(5)(6)(7)(8)
Description
Indicates the status of the module power supply.
On in green: Power-on
Off: Power-off
Indicates the module status.
On in red: Error ( Page 407 When the SF LED turns on in red)
Flashing in red: Force mode
Off: No error
Indicates a communication error.
On in red: Fieldbus error ( Page 407 When the BF LED turns on in red)
Flashing in red: Error ( Page 408 When the BF LED is flashing in red)
Off: No error
Shows the status of the NZ2FT-EIP and modules.
On in yellow: Error ( Page 408 When the MT LED turns on in yellow)
Off: No error
Indicates the fieldbus status.
On: Connection is established between P1 of the NZ2FT-EIP and other field devices.
Flashing: Data is being exchanged at P1 of the NZ2FT-EIP.
When it is on/flashing in green, the data communication speed is 100Mbps, and when it is on/flashing in yellow, the data
communication speed is 10Mbps.
Off: Connection is not established between P1 of the NZ2FT-EIP and other field devices. ( Page 408 When the L/A P1 LED
and L/A P2 LED turn off).
Same as L/A P1 LED.
Indicates the module status.
On in red: I/O module configuration error or fieldbus error ( Page 408 When the MS LED turns on in red)
Flashing in red: I/O module configuration error ( Page 408 When the MS LED is flashing in red)
On in green: Operation preparation completed
Flashing in green: NZ2FT-EIP configuration not set
Flashing in red/green: LED self-diagnostics
Off: Power-off