Table of Contents
Advertisement
GO-5000M-PMCL-UV User Manual (Ver. 1.1)
Example: Change the PixelFormat setting (ImageFormatControl)
1. To check the current PixelFormat setting, enter the command BA?<CR><LF> from the terminal
emulator software.
2. To change the PixelFormat setting to Mono10, enter BA=1<CR><LF>.
Step 5: Adjust the Image Quality
Display the camera image and adjust the image quality.
Display the Image
Display the image captured by the camera. Please display the image with the viewer on the frame
grabber board application.
Adjust the Gain
The gain control uses Analog Base Gain and Digital Gain.
Analog Base Gain can be set at 0dB, +6dB or +12dB.
l
The Digital Gain is used for the master gain setting.
l
For setting the gain,
1. Set Analog Gain (select from 0dB, +6dB and +12dB).
2. Set Digital Gain.
The master gain (DigitalAll) can be set x1 (0dB) to x16 (+24dB) against the analog base gain.
The resolution for gain setting is x0.01/step which is 0.05dB to 0.08dB, depending on the setting
value.
Item
GainRawDigitalAll
AnalogBaseGainAll
GainAuto
Short ASCII
Command
It can be set in the range from 1 time to 16 times. Please specify with a
FGA
value between 100 and 1600.
ABALL
It can be set in the range from 0 to 2. (0: 0dB, 1: 6dB, 2: 12dB)
AGC
0: Off, 1: Continuous
Values
- 22 -
Preparation
Advertisement
Table of Contents
