Configuring The Output - Endress+Hauser Proline Prosonic Flow E 100 HART Operating Instructions Manual

Proline Prosonic Flow E 100 HART
Parameter
Operating mode
Assign pulse output 1
Value per pulse
Pulse width
Failure mode
Invert output signal
Endress+Hauser
Switch-off delay
Failure mode
Invert output signal
Configuring the pulse output
Navigation
"Setup" menu → Pulse/frequency/switch output 1
Parameter overview with brief description
Prerequisite
–
The Pulse option is selected in
the Operating mode
parameter parameter.
In the Operating mode
parameter, the Pulse option is
selected, and one of the
following options is selected in
the Assign pulse output
parameter (→  49):
• Volume flow
• Mass flow
In the Operating mode
parameter, the Pulse option is
selected, and one of the
following options is selected in
the Assign pulse output
parameter (→  49):
• Volume flow
• Mass flow
In the Operating mode
parameter, the Pulse option is
selected, and one of the
following options is selected in
the Assign pulse output
parameter (→  49):
• Volume flow
• Mass flow
–
Configuring the frequency output
Navigation
"Setup" menu → Pulse/frequency/switch output 1
Description
Define the output as a pulse,
frequency or switch output.
Select process variable for
pulse output.
Enter measured value at which
a pulse is output.
Define time width of the
output pulse.
Define output behavior in
alarm condition.
Invert the output signal.
Commissioning
→  53
→  54
→  49
Selection / User Factory setting
entry
• Pulse Pulse
• Frequency
• Switch
• Off Off
• Volume flow
• Mass flow
Signed floating-point Depends on country
number and nominal
diameter
0.05 to 2 000 ms 100 ms
• Actual value No pulses
• No pulses
• No No
• Yes
49