Endress+Hauser Proline Prosonic Flow E 100 HART Operating Instructions Manual page 52

Commissioning
Parameter
Failure mode
Failure frequency
Invert output signal
* Visibility depends on order options or device settings
Parameter
Operating mode
Switch output function
52
Prerequisite
In the Operating mode
parameter, the Frequency
option is selected, and one of
the following options is
selected in the Assign
frequency output parameter
(→  50):
• Volume flow
• Mass flow
• Sound velocity
• Flow velocity
• Temperature
• Acceptance rate
• Signal strength
• Signal to noise ratio
• Turbulence
• Signal asymmetry
In the Operating mode
parameter, the Frequency
option is selected, and one of
the following options is
selected in the Assign
frequency output parameter
(→  50):
• Volume flow
• Mass flow
• Sound velocity
• Flow velocity
• Temperature
• Acceptance rate
• Signal strength
• Signal to noise ratio
• Turbulence
• Signal asymmetry
–
Configuring the switch output
Navigation
"Setup" menu → Pulse/frequency/switch output 1
Parameter overview with brief description
Prerequisite
–
The Switch option is selected
in the Operating mode
parameter.
Description
Define output behavior in
alarm condition.
Enter frequency output value
in alarm condition.
Invert the output signal.
Description
Define the output as a pulse,
frequency or switch output.
Select function for switch
output.
Proline Prosonic Flow E 100 HART
Selection / User Factory setting
entry
• Actual value 0 Hz
• Defined value
• 0 Hz
0.0 to 12 500.0 Hz 0.0 Hz
• No No
• Yes
Selection / User Factory setting
entry
• Pulse Pulse
• Frequency
• Switch
• Off Off
• On
• Diagnostic
behavior
• Limit
• Flow direction
check
• Status
Endress+Hauser