Pending Diagnostic Events - Endress+Hauser Proline Prosonic Flow E 100 HART Operating Instructions Manual

Diagnostics and troubleshooting
80
Diagnostic Short text
number
Diagnostic of process
803 Current loop
832 Electronic temperature
too high
833 Electronic temperature
too low
834 Process temperature too
high
835 Process temperature too
low
840 Sensor range
842 Process limit
881 Sensor signal path 1 to n 1. Check process conditions
882 Input signal
1) Diagnostic behavior can be changed.
12.7

Pending diagnostic events

The Diagnostics menu allows the user to view the current diagnostic event and the
previous diagnostic event separately.
To call up the measures to rectify a diagnostic event:
• Via Web browser →  75
• Via "FieldCare" operating tool →  76
• Via "DeviceCare" operating tool →  76
Other pending diagnostic events can be displayed in the Diagnostic list submenu
→  81
Navigation
"Diagnostics" menu

Diagnostics
Actual diagnostics
Previous diagnostics
Operating time from restart
Operating time
Proline Prosonic Flow E 100 HART
Remedy instructions
1. Check wiring
2. Change I/O module
Reduce ambient temperature
Increase ambient temperature
Reduce process temperature
Increase process temperature
Check flow velocity
Low flow cut off active!
1. Check low flow cut off
configuration
2. Replace sensor electronic module
(ISEM)
3. Replace device
1. Check input configuration
2. Check external device or process
conditions
Status Diagnostic
signal behavior
[from the [from the
factory] factory]
F Alarm
1)
S Warning
1)
S Warning
1)
S Warning
1)
S Warning
1)
S Warning
S Warning
1)
M Warning
F Alarm
→  81
→  81
→  81
→  81
Endress+Hauser