Configuring The Totalizer; Configuration Management - Endress+Hauser Proline Prosonic Flow E 100 HART Operating Instructions Manual

Commissioning
Parameter
Installation direction
Parameter
Assign process variable
Unit totalizer 1 to n
Totalizer operation mode
Failure mode
58
Parameter overview with brief description
Description
Set sign of flow direction to match the
direction of the arrow on the sensor.
10.5.3

Configuring the totalizer

In the "Totalizer 1 to n" submenu the individual totalizer can be configured.
Navigation
"Setup" menu → Advanced setup → Totalizer 1 to n
‣
Totalizer 1 to n
Assign process variable
Unit totalizer 1 to n
Totalizer operation mode
Failure mode
Parameter overview with brief description
Prerequisite
–
One of the following options is
selected in the Assign process
variable parameter (→  58)
of the Totalizer 1 to n
submenu:
• Volume flow
• Mass flow
One of the following options is
selected in the Assign process
variable parameter (→  58)
of the Totalizer 1 to n
submenu:
• Volume flow
• Mass flow
One of the following options is
selected in the Assign process
variable parameter (→  58)
of the Totalizer 1 to n
submenu:
• Volume flow
• Mass flow
10.5.4

Configuration management

After commissioning, you can save the current device configurationor restore the previous
device configuration.
Selection
• Flow in arrow direction
• Flow against arrow direction
Description
Select process variable for
totalizer.
Select process variable totalizer
unit.
Select totalizer calculation
mode.
Define totalizer behavior in
alarm condition.
Proline Prosonic Flow E 100 HART
Factory setting
Flow in arrow direction
→  58
→  58
→  58
→  58
Selection Factory setting
• Off Volume flow
• Volume flow
• Mass flow
Unit choose list Country-specific:
• m³
• ft³
• Net flow total Net flow total
• Forward flow total
• Reverse flow total
• Stop Stop
• Actual value
• Last valid value
Endress+Hauser