Table of Contents
Advertisement
Proline Teqwave MW 300 HART
Parameter
Terminal number
Signal mode
Process variable current output
Endress+Hauser
10.5.6
Configuring the current output
The Current output wizard guides you systematically through all the parameters that have
to be set for configuring the current output.
Navigation
"Setup" menu → Current output
‣
Current output 1 to n
Terminal number
Signal mode
Process variable current output
Current range output
Lower range value output
Upper range value output
Fixed current
Damping current output
Failure behavior current output
Failure current
Parameter overview with brief description
Prerequisite
–
–
The Load rate option is only
available if the volume flow of
the medium is read in via the
Current input 1 to n or the
fieldbus.
Description
Shows the terminal numbers
used by the current output
module.
Select the signal mode for the
current output.
Select the process variable for
the current output.
Commissioning
→ 87
→ 87
→ 87
→ 88
→ 88
→ 88
→ 88
→ 88
→ 88
→ 88
User interface /
Factory setting
Selection / User
entry
• Not used
–
• 26-27 (I/O 1)
• 24-25 (I/O 2)
• 22-23 (I/O 3)
*
• Active
Active
*
• Passive
• Off
Total solids
• Total solids
• Temperature
• Electronics
temperature
• Conductivity
• Corrected
conductivity
*
• Load rate
87
Advertisement
Table of Contents
