Obsolete Commands; Changed Parameter Syntax And Semantics - Agilent Technologies 8163A Programming Manual

Obsolete Commands

Old Command
DISPlay:STATe/?
PROGram command tree
Return Loss Module Commands The commands for the return loss modules will be com-
Command
SOUR:AM:FREQ/?
DISP:BRIG
SENS:CORR:COLL:ZERO?
SENS:POW:REF
Agilent 8163A Lightwave Multimeter, Agilent 8164A Lightwave Measurement System, & Agilent 8166A Lightwave Multichannel
System, Third Edition
Obsolete Commands
Table 11 contains details of commands that have been directly replaced.
Table 11 Obsolete Commands
Changed Parameter Syntax and
Semantics
Table 12 details commands whose parameter syntax or semantics have
changed.
Table 12 Commands with Different Parameters or Syntax
New Command
DISPlay:ENABle/?
SENSe:FUNCtion command tree.
Some commands from the PROGram command tree
have not been replaced.
The HP 8153A application interface on the GPIB is not
supported.
Stability/Logging and Min/Max are available via a new
interface.
pletely different than those for the HP 8153A.
Change
This command does not accept the value CW, instead
use SOUR:AM:STAT ON|OFF to switch from and to CW
mode.
The commands accepts floating point values.
This command now supports integers between 1 and
100, instead of float values between 1 and 0.
This command returns the last zero state, instead of the
last remote zero state.
Accepts TOMODule and TOREF for the first parame-
ter, instead of accepting TOA|TOB as the HP 8153A
does. The numbers 0|1|2 cannot be used, only the
strings above.
GPIB Command Compatibility List
Affects
8153
8153
8153
Affects
8153
8153
8153
8153
187