Agilent Technologies 8163A Programming Manual page 48

Instrument Setup and Status
command:
syntax:
description:
parameters:
response:
example:
command:
syntax:
description:
parameters:
response:
example:
48
*ESE
*ESE<wsp><value>
0 ≤ value ≤ 255
The standard Event Status Enable command (*ESE) sets bits in the Standard Event Status
Enable Mask (SESEM) that enable the corresponding bits in the standard event status reg-
ister (SESR).
The register is cleared:
• at power-on,
• by sending a value of zero.
The register is not changed by the *RST and *CLS commands.
The bit value for the register (a 16-bit signed integer value):
Bit Mnemonic
7 (MSB) Power On
6 Not Used
5 Command Error
4 Execution Error
3 Device Dependent Error
2 Query Error
1 Not Used
0 (LSB) Operation Complete
none
*ESE 21
*ESE?
*ESE?
The standard Event Status Enable query *ESE? returns the contents of the Standard
Event Status Enable Mask (see *ESE for information on this register).
none
The bit value for the register (a 16-bit signed integer value).
*ESE? → 21<END>
Agilent 8163A Lightwave Multimeter, Agilent 8164A Lightwave Measurement System,
& Agilent 8166A Lightwave Multichannel System, Third Edition
IEEE-Common Commands
Decimal Value
128
0
32
16
8
4
0
1