Agilent Technologies 8163A Programming Manual page 114

Measurement Operations & Settings
command:
syntax:
description:
parameters:
response:
example:
affects:
command:
syntax:
description:
parameters:
response:
example:
affects:
command:
syntax:
description:
parameters:
response:
example:
affects:
command:
syntax:
description:
parameters:
response:
example:
affects:
114
[:SOURce[n]][:CHANnel[m]]:WAVelength:SWEep:SPEed?
[:SOURce[n]][:CHANnel[m]]:WAVelength:SWEep:SPEed?
Returns the speed for continuous sweeping.
none
Speed as a float value in meters per second (m/s).
→
wav:swe:spe? +5.00000000E-008<END>
All tunable laser modules except Agilent 81689A
[:SOURce[n]][:CHANnel[m]]:WAVelength:SWEep:STARt
[:SOURce[n]][:CHANnel[m]]:WAVelength:SWEep:STARt<wsp><start value>
[PM|NM|UM|MM|M]
Sets the starting point of the sweep.
The wavelength at which the sweep starts as a float value.
If you specify no units in your command, meters are used as the default.
none
wav:swe:star 1500nm
All tunable laser modules
[:SOURce[n]][:CHANnel[m]]:WAVelength:SWEep:STARt?
[:SOURce[n]][:CHANnel[m]]:WAVelength:SWEep:STARt?
Returns the starting point of the sweep.
none
The wavelength at which the sweep starts as a float value in meters.
→
wav:swe:star?
All tunable laser modules
[:SOURce[n]][:CHANnel[m]]:WAVelength:SWEep:STOP
[:SOURce[n]][:CHANnel[m]]:WAVelength:SWEep:STOP<wsp><stop value>
[PM|NM|UM|MM|M]
Sets the end point of the sweep.
The wavelength at which the sweep ends as a float value in meters.
If you specify no units in your command, meters are used as the default.
none
wav:swe:stop 1550nm
All tunable laser modules
Agilent 8163A Lightwave Multimeter, Agilent 8164A Lightwave Measurement System,
& Agilent 8166A Lightwave Multichannel System, Third Edition
Signal Generation – The SOURce Subsystem
+1.50000000E-006<END>