Agilent Technologies 8163A Programming Manual page 113

Signal Generation – The SOURce Subsystem
command:
syntax:
description:
parameters:
response:
example:
affects:
command:
syntax:
description:
parameters:
response:
example:
affects:
command:
syntax:
description:
parameters:
response:
example:
affects:
Agilent 8163A Lightwave Multimeter, Agilent 8164A Lightwave Measurement System, & Agilent 8166A Lightwave Multichannel
System, Third Edition
[:SOURce[n]][:CHANnel[m]]:WAVelength:SWEep:REPeat
[:SOURce[n]][:CHANnel[m]]:WAVelength:SWEep:REPeat<wsp><mode>
Sets the repeat mode.
ONEWay: every sweep cycle starts at the start wavelength of the sweep and ends at
the stop wavelength of the sweep
TWOWay: odd sweep cycles start at the start wavelength of the sweep and even sweep
cycles start at the stop wavelength of the sweep
Set the start and stop wavelength of the sweep using
"[:SOURce[n]][:CHANnel[m]]:WAVelength:SWEep:STARt" on page 114
and "[:SOURce[n]][:CHANnel[m]]:WAVelength:SWEep:STOP" on
page 114 respectively.
none
wav:swe:rep twow
All tunable laser modules
[:SOURce[n]][:CHANnel[m]]:WAVelength:SWEep:REPeat?
[:SOURce[n]][:CHANnel[m]]:WAVelength:SWEep:REPeat?
Returns the repeat mode.
none
ONEW: every sweep cycle starts at the start wavelength of the sweep and ends at the
stop wavelength of the sweep
TWOW:
odd sweep cycles start at the start wavelength of the sweep and even sweep
cycles start at the stop wavelength of the sweep
Set the start and stop wavelength of the sweep using
"[:SOURce[n]][:CHANnel[m]]:WAVelength:SWEep:STARt" on page 114 and
"[:SOURce[n]][:CHANnel[m]]:WAVelength:SWEep:STOP" on page 114
respectively.
→
wav:swe:rep? ONEW<END>
All tunable laser modules
[:SOURce[n]][:CHANnel[m]]:WAVelength:SWEep:SPEed
[:SOURce[n]][:CHANnel[m]]:WAVelength:SWEep:SPEed<wsp><speed>
[NM/S|UM/S|MM/S|M/S|]
Sets the speed for continuous sweeping.
Speed as a float value in meters per second (m/s).
none
wav:swe:spe 10nm/s
All tunable laser modules except Agilent 81689A
Measurement Operations & Settings
113