Agilent Technologies 8163A Programming Manual page 41

Specific Command Summary
Command
:FREQuency/?
:REFerence?
[:SOURce[n]][:CHANnel[m]:]WAVelength:CORRection
:ARA
:ZERO
[:SOURce[n]][:CHANnel[m]:]WAVelength:REFerence
:DISPlay
[:SOURce[n]][:CHANnel[m]:]WAVelength:SWEep
:CYCLes/?
:DWELl/?
:LLOGging/?
:MODE/?
:PMAX?
:REPeat/?
:SPEed/?
:STARt/?
:STOP/?
[:STATe]/?
[:SOURce[n]][:CHANnel[m]:]WAVelength:SWEep:STEP
:NEXT
:PREVious
[:WIDTh]/?
:SPECial
:REBoot
:STATus[n]
:PRESet
:STATus:OPERation
Agilent 8163A Lightwave Multimeter, Agilent 8164A Lightwave Measurement System, & Agilent 8166A Lightwave Multichannel
System, Third Edition
Table 4 Specific Command Summary (continued)
Description
Sets the frequency difference used to calculate a relative wave-
length for a source.
Returns the reference wavelength of a source.
Realigns the laser cavity.
Exexutes a wavelength zero.
Sets the reference wavelength of a source to the value of the output
wavelength.
Sets or returns the number of cycles.
Sets or returns the dwell time.
Switches lambda logging on or off or queries the state of lambda
logging.
Sets or returns the sweep mode.
Returns the highest permissible power for a wavelength sweep.
Sets or returns the repeat mode.
Sets or returns the speed for continuous sweeping.
Sets or returns the start point of the sweep.
Sets or returns the end point of the sweep.
Stops, starts, pauses or continues a wavelength sweep or returns
the the state of a sweep.
Performs the next sweep step.
Performs the previous sweep step again.
Sets or returns the width of the sweep step.
Reboots the mainframe and all modules.
Presets all Enable Registers.
Specific Commands
Page
page 108
page 108
page 107
page 107
page 109
page 109
page 110
page 111
page 112
page 112
page 113
page 113
page 114
page 114
page 115
page 115
page 115
page 116
page 72
page 58
41