Agilent Technologies 8163A Programming Manual page 124

Measurement Operations & Settings
command:
syntax:
description:
parameters:
NO TE
response:
example:
command:
syntax:
description:
parameters:
response:
example:
command:
syntax:
description:
parameters:
response:
example:
124
You can configure the ouputs and inputs from two nodes, Node A and
Node B. See Figure 6 on page 125 for more information on Node A and
Node B. You can configure these nodes to be triggered by certain events
and for these nodes to trigger particular actions.
:TRIGger
:TRIGger<wsp>NODEA|1|NODEB|2
Generates a hardware trigger.
1 or NODEA:
2 or NODEB:
Use ":TRIGger:CONFiguration:EXTended" on page 124 to configure Node A and Node B.
":TRIGger" on page 118 describes the :TRIGger command for basic users.
none
trig 1
:TRIGger:CONFiguration:EXTended
:TRIGger:CONFiguration:EXTended<wsp><Node A Input Config.>,
<Node B Input Config.>,<Output Matrix Config.>
Sets the extended hardware trigger configuration.
Node A Input Configuration:
Node B Input Configuration:
Output Matrix Configuration:
none
trig:conf:ext 0,0,0
:TRIGger:CONFiguration:EXTended?
:TRIGger:CONFiguration:EXTended?
Returns the extended hardware trigger configuration.
none
Node A Input Configuration:
Node B Input Configuration:
Output Matrix Configuration:
trig:conf:ext? → +0,+0,+0<END>
Agilent 8163A Lightwave Multimeter, Agilent 8164A Lightwave Measurement System,
& Agilent 8166A Lightwave Multichannel System, Third Edition
Triggering - The TRIGger Subsystem
Generates trigger at Node A.
Generates trigger at Node B.
A 32-bit unsigned integer, see below.
A 32-bit unsigned integer, see below.
A 32-bit unsigned integer, see below.
A 32-bit unsigned integer, see below.
A 32-bit unsigned integer, see below.
A 32-bit unsigned integer, see below.