Agilent Technologies 8163A Programming Manual page 115

Signal Generation – The SOURce Subsystem
command:
syntax:
description:
parameters:
response:
example:
affects:
command:
syntax:
description:
parameters:
NO TE
response:
example:
affects:
command:
syntax:
description:
parameters:
response:
example:
affects:
command:
syntax:
description:
parameters:
response:
example:
affects:
Agilent 8163A Lightwave Multimeter, Agilent 8164A Lightwave Measurement System, & Agilent 8166A Lightwave Multichannel
System, Third Edition
[:SOURce[n]][:CHANnel[m]]:WAVelength:SWEep:STOP?
[:SOURce[n]][:CHANnel[m]]:WAVelength:SWEep:STOP?
Returns the end point of the sweep.
none
The wavelength at which the sweep ends as a float value in meters.
→
wav:swe:stop?
All tunable laser modules
[:SOURce[n]][:CHANnel[m]]:WAVelength:SWEep:[STATe]
[:SOURce[n]][:CHANnel[m]]:WAVelength:SWEep:[STATe]<wsp>
STOP|0|STARt|1|PAUSe|2|CONTinue|3
Stops, starts, pauses or continues a wavelength sweep.
0 or STOP:
1 or STARt:
2 or PAUSe:
3 or CONTinue:
When you enable lambda logging, see
"[:SOURce[n]][:CHANnel[m]]:WAVelength:SWEep:LLOGging" on page 111, and
modulation, see "[:SOURce[n]][:CHANnel[m]]:AM:STATe[l]" on page 96,
simultaneously, a sweep can not be started.
none
wav:swe STOP
All tunable laser modules
[:SOURce[n]][:CHANnel[m]]:WAVelength:SWEep:[STATe]?
[:SOURce[n]][:CHANnel[m]]:WAVelength:SWEep:[STATe]?
Returns the state of a sweep.
none
+0:
+1:
→
+0<END>
wav:swe?
All tunable laser modules
[:SOURce[n]][:CHANnel[m]]:WAVelength:SWEep:STEP:NEXT
[:SOURce[n]][:CHANnel[m]]:WAVelength:SWEep:STEP:NEXT
Performs the next sweep step, if a manual sweep is paused.
none
none
wav:swe:step:next
All tunable laser modules
+1.55000000E-006<END>
Stop the sweep.
Start a sweep, run sweep.
Pause the sweep.
Continue a sweep.
Sweep is not running
Sweep is running
Measurement Operations & Settings
115