Table of Contents
Advertisement
4.38 P
ROGRAMMING
F
7
UNCTION
F
71
UNCTION
F
72
UNCTION
F
73
UNCTION
R
EPORTS
S
P
ERIAL
RINTER
Connect a standard serial printer to the serial port of the sys-
tem. The output from the serial port is: 8 data bits, 1 stop bit,
and no parity. The baud rate is programmed by the Installer in
Function 18. The pinout is: Data Transmit – Pin 2, Receive –
Pin 3, and Ground – Pin 5.
PC I
NTERFACE
Connect a computer serial port to the serial port of IVX. Use a
standard PC communications program such as ProCom to port
the data to the PC. When printing from the PC to a laser printer
use a Fixed Proportional Font such as Courier New, 9 points or
smaller.
From either the Installer or Administrator programming menu
select the desired report as listed below. The reports can be
printed with either: (1) the data saved for inclusion in future
reports, or (2) the data and totals cleared. The System
Program Report or System Speed Dial Report cannot have its
data cleared.
Note: Outbound calls shorter than one minute are not counted
in system totals.
S
P
YSTEM
ROGRAM
This report provides a hard copy of the system's current pro-
gramming. This report can be compared against the
Programmers Worksheet to verify the accuracy of the pro-
grammed data.
L
/ A
A
INE
UTO
TTENDANT
This report provides statistics to aid in analysis of Line usage
and requirements.
E
/ D
XTENSION
EPARTMENT
This report provides extension usage.
R
EPORT
R
EPORT
R
EPORT
IVX
Advertisement
Table of Contents
