Table of Contents
Advertisement
4.10 P
IVX
ROGRAMMING
F
21
CO L
P
UNCTION
INE
ROGRAMMING
Up to 16 CO Loop Start Lines can be connected to the system
(8 to the standard cabinet and 8 to the expansion cabinet). The
CO Lines are numbered 1 to 16.
All CO Lines are programmed to route callers during the Day
Mode then all CO Lines are programmed to route callers during
the Night Mode. The LCD Display will indicate DAY or NIGHT to
distinguish which mode is currently being programmed.
See the Tutorial (Section 2) for programming examples. Below
is an example of a completed Programming Worksheet. The
sequence of programming is as follows:
1.
2.
3.
CO
OUT
Ring 1 Ring 3 Ring 5 Ring 9
1
9
100
100
100
ID1
E
:
ACH PROGRAMMING STEP IS DEFINED AS FOLLOWS
1. C
CO L
P
HOOSE
INES TO
ROGRAM
Select the Line Keys to be programmed alike (their LEDs will
become green when selected). After programming these keys
(they will turn amber), select additional Line Keys to program
alike until all required Lines have been programmed (and turned
amber). Repeat this for the Night Mode.
2. O
CO L
G
UTBOUND
INE
ROUPS
CO Lines can be grouped for outbound pooled access into one
of three Line Groups (9, 8, or 7).
Note: A Line can only be in one Line Group.
Outgoing calls, if selected by dialing 9, 8, or 7 access; will be
assigned in order from the highest numbered CO Line to the
lowest in the group. If a CO Line is not assigned to a Line
Group, it will be an inbound line only (press the HOLD Key to
delete the Line Group number).
Default is all CO Lines in Group 9.
Advertisement
Table of Contents
