Table of Contents
Advertisement
IVX
LED F
UNCTION
P
LED
OWER
P
LED
ORT
S
M
T
EMORY
RANSFER
The unit's various LEDs are designed to provide visual feedback
as follows:
The Power LED is located on the top-right side of the cabinet
and is illuminated when power is being applied to the system.
The LED blinks periodically to indicate that the main processor
is operational.
The Port LEDs are located above their respective Amphenol
connectors on the right side of the cabinet. Each LED is illumi-
nated when CO traffic is currently being processed by its card.
Caution: Disconnecting an Amphenol connector when its
respective LED is lit will cause one or more outside calls to be
disconnected.
Note: Upon power-up, approximately 30 seconds are required
for the system to configure. The Power and Port LEDs will blink
three times to indicate that the power up sequence has been
completed.
LED
This LED is located inside the cabinet on the top center of the
main board and flashes as data is transferred to and from the
Memory Module.
H
I
ARDWARE
NSTALLATION
2.11
Advertisement
Table of Contents
