Pluggable Transceivers Supported On Ex3300 Switches - Juniper EX3300 Complete Hardware Manual

Complete Hardware Guide for EX3300 Ethernet Switches
Table 18: Management Port Connector Pinout Information for EX3300 Switches (continued)
Pin
7
8
Related
Documentation

Pluggable Transceivers Supported on EX3300 Switches

30
Signal
TRP4+
This pin is used only when the port is
operating at 1000 Mbps.
TRP4-
This pin is used only when the port is
operating at 1000 Mbps.
See Rear Panel of an EX3300 Switch on page 7
Connecting a Switch to a Network for Out-of-Band Management on page 109
Uplink ports on the front panel in EX3300 switches support SFP and SFP+ transceivers.
This topic describes the optical interfaces supported for those transceivers.
NOTE: We recommend that you use only optical transceivers and optical
connectors purchased from Juniper Networks with your Juniper Networks
device.
CAUTION: If you are having a problem running a Juniper Networks device
that is using a third-party optic or cable, the Juniper Networks Technical
Assistance Center (JTAC) can help you diagnose the source of the problem.
Your JTAC engineer might recommend that you check the third-party optic
or cable and potentially replace it with an equivalent Juniper Networks optic
or cable that is qualified for the device.
The Gigabit Ethernet SFP and SFP+ transceivers installed in EX3300 switches support
digital optical monitoring (DOM): you can view the diagnostic details for these transceivers
by issuing the operational mode CLI command
NOTE: The transceivers support DOM even if they are installed in uplink ports
configured as Virtual Chassis ports.
Description
Transmit/receive data pair 4
Transmit/receive data pair 4
for port location.
show interfaces diagnostics optics
Copyright © 2015, Juniper Networks, Inc.
.