Table of Contents
Advertisement
the parameter preview area.
Warning
To avoid electric shock, ensure that the DUT is connected to the input
terminals of the load properly before you turn on the channel input.
4. View waveform
Press Display key to enter the waveform display interface, as shown in
figure 2-44. Here, you can observe the measured performance of the
input signal. Change the Data label (I, V, P, or R) to view a different
parameter. Press the Display key again to exit the waveform display
interface and return to the main interface of List test mode.
Figure 2-44 Waveform display interface of List mode
5. Storage
In the List function interface, you can press "Save" to save the
parameters for List mode to the internal or external memory, and you
can read and recall it if necessary by pressing "Recall". Up to eight List
files can be stored internally.
Auto Test Function
The Auto test function of the Teledyne Test Tools T3EL15030xP electronic load
is very powerful. It allows for multiple steps, similar to List mode. The biggest
difference is that it can also change the test function type (CC, CV, CP, CR,
48
Advertisement
Table of Contents
