Table of Contents
Advertisement
The parameters for the OPPT test mode include range, OPP_V,P_Step,
P_Start, P_End, P_MIN, P_MAX, Delay.
The interface menu can be divided into three pages.
Set range
Current range: 5 A or 30 A
Voltage range: 36 V or 150 V
Set OPP_V
The protection voltage of the OPPT test function. The default unit for
the value is Volts (V).
Set P_Step
The step power for the OPPT test function. The default unit for I_Step
is Watts (W).
Set P_Start
The sink power when the load starts the OPPT test sequence. The
default unit for P_Start is Watts (W).
Set P_End
The sink power when the load stops the OPPT test sequence. The
default unit for P_End is Watts (W).
Set P_MIN
The minimum value of the protection power in the OPPT test function.
The default unit for P_End is Watts (W).
Set P_MAX
The maximum value of the protection power in the OPPT test function.
The default unit for I_End is Watts (W).
Set Delay
The time interval during which the power moves from step-to-step in
OPPT test function. The default unit for Delay is seconds (s).
3. Turn on the input channel
Press On/Off to turn on the channel input. At this time, the actual input
voltage, current, resistance and power will be displayed on the main
interface. If the OPPT test results are a pass, the interface of the load
40
Advertisement
Table of Contents
