Table of Contents
Advertisement
The GPIB Load address range is from 0-30. The default address of GPIB is 1
which is stored in the non-volatile memory and is not influenced by restoration
of factory settings.
Set the parameters of the LAN interface
Before using the LAN interface, connect the load to a computer or the local
area network (LAN) where the computer is visible and ensure sufficient
connectivity.
Press Interface to enter the communication interface tab, and then press the
"LAN" key to select the "LAN" tab to enter the network parameter setting
interface, as shown in Figure 3-8.
In this interface, you can view the network connection status and configure the
network parameters such as IP address, subnet mask, default gateway and
DHCP status. The setting is stored in the non-volatile memory and is not
influenced by restoring factory settings.
Figure 3-7 GPIB Interface
Figure 3-8 LAN Interface
71
Advertisement
Table of Contents
