Table of Contents
Advertisement
3. Turn on the input channel
Press On/Off to turn on the channel input. At this time, the actual sink
voltage, current, power, resistance will be displayed on the main
interface.
Note: Once the channel input is turned on, the load will not start to sink
the current until the input voltage is greater than the break-over
voltage.
4. View waveform
Press Display key to enter waveform display interface, as shown in
figure 3-15. By means of observe waveform of ExtV mode after set the
Data selection be "V", user can see the trend of the sink voltage. Press
the Display key again to exit the waveform display interface and return
to the main interface of ExtV mode.
Figure 3-15 Waveform display interface of ExtV mode
81
Advertisement
Table of Contents
