Table of Contents
Advertisement
Warning
To avoid electric shock, ensure that the DUT is connected to the
input terminals of the load properly before you turn on the channel
input.
8. Press the Display key to enter the waveform display interface, as shown in
Figure 2-4. By default, the current waveform is displayed. When the input
voltage changes, the load will sink a constant current.
Press the Display key again to exit the waveform display interface and
return to the main interface of CC mode.
Figure 2-4 Waveform display interface of CC Mode
Constant Voltage (CV) Mode
In CV mode, the electronic load will sink enough current to maintain the input
voltage at the setpoint, as shown in Figure 2-5.
17
Advertisement
Table of Contents
