Teledyne T3EL15030 P Series User Manual page 61

Note:
The load only supports FAT32 USB flash drives.
1. Local(C:)
User can save the currently set state files to the local storage area
and recall them when necessary. Eight list files and ten program files
can be saved to the local drive.
2. USB(D:)
Disk D is only available when a USB storage device is detected over
the USB HOST interface on the front panel. You can save the
currently set state files and data files of various function modes to the
USB storage device and you can also copy the files from Disk C to
Disk D. The number of files that can be saved is determined by the
storage space of the disk.
Press Restore key on the front panel of the load to enter the storage and
recall interface, as shown in Figure 2-49.
Figure 2-49 Storage and Recall Interface under CC mode
Save
Operating Steps
1. Press Restore to enter storage interface, then enter the file
catalogue list in List/Program.
2. User can select an arbitrary file in the files catalogue in List/
Program, then click "Save" to enter file name edit interface
which is default display "Default", as shown in figure 2-50.
58