Table of Contents
Advertisement
To Power on the instrument
After the instrument is connected to the power source, press the Power key at
the left bottom of the front panel to power on the instrument. When the
instrument is turned on, it will undergo a self-test. If the instrument passes the
self-test, the welcome interface is displayed; otherwise, self-test failure
information will be displayed. If this does occur please contact Teledyne LeCroy.
Fuse Replacement
The specifications of the fuse are relative to the actual input line voltage, shown
in the table below. You can also refer to the rear panel "Input power
requirement".
To replace the fuse, please follow the steps below:
1.
Turn off the instrument and remove the power cord.
2.
Insert a small straight screwdriver into the slot at the power socket
and gently pry out the fuse seat.
3.
Adjust the power voltage selector manually to select the correct
voltage scale.
4.
Take out the fuse and replace it with the specified fuse (to check
the relationship between the input voltage and the fuse
specification, refer to the "Input power requirement" on the rear
panel).
5.
Re-insert the fuse holder into the power socket (please pay
attention to the alignment).
WARNING
To avoid personal injuries, unplug the power supply before replacing the
fuse. To avoid electric shock or fire, select the proper power supply
specification and the correctly rated fuse.
12
Input voltage
110 VAC
220 VAC
Fuse specification
T315 mA / 250V
T315 mA / 250V
Advertisement
Table of Contents
