Teledyne T3EL15030 P Series User Manual page 27

Programmable dc electronic load

Table of Contents

Figure 2-13 Waveform display interface of CP Mode

Dynamic test function

In dynamic test operation, the electronic load can be switched between two

parameters based on the set values. This can be useful when testing the

dynamic performance of a power supply or source. Press Shift + CC key on the

front panel to enter the dynamic test interface.

Before testing, it is important to configure the load set points: A value, B value,

pulse width time, frequency, duty ratio,etc. The rise and fall slew rates are also

important settings for dynamic testing.

Dynamic test supports three modes:

� Continuous

� Pulse

� Toggle

Table of Contents

T3el150302p T3el150303p