Power; Ac Power; Power Consumption; Ground - Teledyne HDO9000 Operator's Manual

Caution: Unplug the power cord from the AC inlet before cleaning to avoid electric shock. Do
not attempt to clean internal parts. Refer all maintenance to qualified service personnel.

Power

AC Power

The instrument operates from a single-phase, 100-240 Vrms (± 10%) AC power source at 50/60 Hz (±
5%) or a 100-120 Vrms (± 10%) AC power source at 400 Hz (± 5%). Manual voltage selection is not
required because the instrument automatically adapts to the line voltage.

Power Consumption

Maximum power consumption with all accessories installed (e.g., active probes, USB peripherals,
digital leadset) is 500 W (500 VA). Power consumption in Standby mode is 15 W.

Ground

The AC inlet ground is connected directly to the frame of the instrument. For adequate protection
again electric shock, connect to a mating outlet with a safety ground contact.
Caution: Only use the power cord provided with your instrument. Interrupting the protective
conductor (inside or outside the case), or disconnecting the safety ground terminal, creates a
hazardous situation. Intentional interruption is prohibited.
Safety
3