HPE ProLiant ML110 Gen10 User Manual page 109

5. Disconnect all peripheral cables from the server.
6.
Do one of the following:
Server in rack mode: Remove the server from the rack.
•
Server in tower mode: Position the tower server for hardware configuration.
•
7. Remove the access panel.
8. Remove the PCI air baffle.
9. Remove the system air baffle.
10. Remove any components or cables that may prevent access to the TPM connector.
11. Proceed to Installing the TPM board and cover.
Installing the TPM board and cover
Procedure
1. Observe the following alerts:
CAUTION: If the TPM is removed from the original server and powered up on a different server, data stored in
the TPM including keys will be erased.
CAUTION: The TPM is keyed to install only in the orientation shown. Any attempt to install the TPM in a
different orientation might result in damage to the TPM or system board.
2. Align the TPM board with the key on the connector, and then install the TPM board. To seat the board, press the TPM
board firmly into the connector. To locate the TPM connector on the system board, see the server label on the access
panel.
3. Install the TPM cover:
a. Line up the tabs on the cover with the openings on either side of the TPM connector.
b. To snap the cover into place, firmly press straight down on the middle of the cover.
Hardware options installation
109