•
Server in rack mode: Remove the server from the rack.
•
Server in tower mode: Position the tower server for hardware configuration.
5.
Remove the access panel.
6.
Remove the PCI air baffle.
7.
Remove the system air baffle.
8.
Install the DIMM:
a. Open the DIMM slot latches.
b. Align the notch on the bottom edge of the DIMM with the keyed surface of the DIMM slot, and then fully press
the DIMM into the slot until the latches snap back into place.
The DIMM slots are structured to ensure proper installation. If you try to insert a DIMM but it does not fit easily
into the slot, you might have positioned it incorrectly. Reverse the orientation of the DIMM and insert it again.
9.
Install the system air baffle.
10. Install the PCI air baffle.
11. Install the access panel.
12. Do one of the following:
Server in rack mode: Install the server into the rack.
•
•
Server in tower mode: Return the server to an upright position.
13. Connect all peripheral cables to the server.
14. Connect each power cord to the server.
15. Connect each power cord to the power source.
16. Power up the server.
The installation is complete.
Hardware options installation
99