Specifications; Environmental Specifications; Mechanical Specifications - HPE ProLiant ML110 Gen10 User Manual

Specifications

Environmental specifications

Specification
Temperature range
Operating
Nonoperating
Relative humidity (noncondensing)
Operating
Nonoperating
1
All temperature ratings shown are for sea level. An altitude derating of 1.0°C per 305 m (1.8°F per 1000 ft) to 3050 m (10,000 ft) is
applicable. No direct sunlight allowed. Maximum rate of change is 20°C per hour (36°F per hour). The upper limit and rate of change
might be limited by the type and number of options installed.
For certain approved hardware configurations, the supported system inlet temperature range is extended:
• 5°C to 10°C (41°F to 50°F) and 35°C to 40°C (95°F to 104°F) at sea level with an altitude derating of 1.0°C per every
175 m (1.8°F per every 574 ft) above 900 m (2953 ft) to a maximum of 3050 m (10,000 ft)
• Redundant fans are required when the ambient temperature reaches 35°C (95°F) to 40°C (104°F).
The approved hardware configurations for this system are listed on the Hewlett Packard Enterprise website (http://
www.hpe.com/servers/ASHRAE).

Mechanical specifications

Dimension (with feet/bezel)
Height
Depth
Width
Weight (approximate)
Minimum (one drive, power supply, and processor installed)
Maximum (all drives, power supplies, and processors installed)
1
Value
—
10°C to 35°C (41°F to 95°F)
-30°C to 60°C (-22°F to 140°F)
—
8% to 90%
28°C (82.4°F), maximum wet bulb temperature
5% to 95%
38.7°C (101.7°F), maximum wet bulb temperature
Value
44.00 cm (17.32 in)
48.05 cm (18.92 in)
19.50 cm (7.68 in)
13.5 kg (29.82 lb)
25.0 kg (55.00 lb)
148
Specifications