Install The Access Panel; Remove The Front Bezel - HPE ProLiant ML110 Gen10 User Manual

Install the access panel

Procedure
1. Install the access panel:
a. Place the access panel on the chassis, and slide it towards the front of the server.
b. Tighten the thumbscrews.
2. If a Kensington security cable was removed, connect it to the rear panel. See the security cable documentation for
instructions.
3. Do one of the following:
• Server in rack mode: Install the server into the rack.
• Server in tower mode: Return the server to an upright position.
4. Connect all peripheral cables to the server.
5. Connect each power cord to the server.
6. Connect each power cord to the power source.
7. Power up the server.

Remove the front bezel

Procedure
1. If the bezel is locked, power down the server.
2. Remove all power:
28
Operations