M.2 Ssd Enablement Option; Installing An M.2 Sata Ssd - HPE ProLiant ML110 Gen10 User Manual

After installing the DIMMs, use the System Utilities > System Configuration > BIOS/Platform Configuration (RBSU) >
Memory Options to configure the memory settings.

M.2 SSD enablement option

The M.2 SSD enablement board is supported in the PCIe3 expansion slots 1, 3, and 4. This enablement board is not a
detectable option in the System Utilities > System Configuration > BIOS/Platform Configuration (RBSU) > Storage
Options > PCIe Storage Boot Policy setting.

Installing an M.2 SATA SSD

Prerequisites
Before you perform this procedure, make sure that you have the following items available:
• M.2 SSD enablement option
• M.2 SSD
• T-15 Torx screwdriver
• Phillips No.1 screwdriver
Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Disconnect all peripheral cables from the server.
4.
Do one of the following:
• Server in rack mode: Remove the server from the rack.
Server in tower mode: Position the tower server for hardware configuration.
•
5. Remove the access panel.
6. Remove the PCI air baffle.
7. Remove the system air baffle.
8. Install the SSD on the M.2 SSD enablement board:
a. Insert the SSD into the SSD slot at a 45° angle.
b. Carefully press the SSD down to the horizontal position.
c. Secure the SSD with a screw.
Hardware options installation
100