User Guide
Recording Cues with Link
Cues can be played back out of their numeric sequence by assigning a Link
to a cue. When a cue is linked to another cue, the execution sequence
continues onward in the list from that destination cue until the end of the
cue list until another link is encountered in a later cue. The assigned link
can be viewed from the Cuesheet or Preview displays.
For example, to link cue 5 to cue 12:
Press [CUE] [5] [LINK] [12] [ENTER].
To assign a link to the
Press [LINK] [#] [ENTER].
Creating Automatic Playback Loops
Follow and Link can be combined to create loops in which cues play back
automatically and repeat.
Follow the example steps below to record an automatic cue playback loop:
Procedure:
1. Create three cues
2. Press [CUESHEET]
3. Press [CUE] [1] [TIME] [2] [FOLLOW] [5] [ENTER]
4. Press down arrow key to highlight cue 2
5. Press [TIME] [2] [FOLLOW] [5] [ENTER]
6. Press down arrow key to highlight cue 3
7. Press [TIME] [2] [FOLLOW] [5] [LINK] [1] [ENTER]
In the above example, cue 1 will start after you load a playback fader with
cue 1 and press [GO]. Cue 2 will follow cue 1, cue 3 will follow cue 2. Cue
1 will start over again because cue 3 is linked to cue 1. For more
information on cue playback see the
chapter.
You can also create loops using effects. These effect loops can then be
played back in a cue or submaster. See
information.
Rev. 1.30.03.07.r1
current
cue being viewed in a display:
Playing Back Cues
Chapter 5 Cues
Notes:
Cue #'s 1, 2, 3.
section later in this
Chapter 7 Effects
for more
Page 63