Leviton 600 User Manual page 173

User Guide
Follow the procedure below to recreate the example tracking cues as in
Figure 10.7 (note that a fade time of 2 sec. is also recorded for each cue):
Procedure:
1. Press (Q Mode) until "Tracking"
appears next to Command Line
2. Press the [DEVICE] display key
3. Press [DEVICE] [1] [ENTER]
4. Press the [DEFAULT] key next to LCD Device will go to default
5. Use the trackball or encoder wheels
to set pan and tilt levels for cue 1
6. Press [RECORD CUE] [1] [TIME] [2]
7. Press [ENTER]
8. Use trackball or encoder wheels to
set new pan and tilt levels for cue 2
9. Press [RECORD CUE] [2] [TIME] [2]
10. Press [ENTER]
11. Use trackball or encoder wheels to
set new pan and tilt levels for cue 3
12. Press [RECORD CUE] [3] [TIME] [2]
13. Press [ENTER]
14. Press [TRACKSHEET] (Device) to
view the tracked cues as in Figure 10.7
To view cues in the Tracksheet which have both devices and channels
recorded, press [S6]. This will toggle back and forth between viewing
devices or channels.
Rev. 1.30.03.07.r1
Chapter 10 Automated Devices
Notes:
Device must already have
been assigned
LCD opens showing
selected device
settings and all traits will be
selected (white) for record in
Device display
All traits of device
recorded in Cue 1
Only pan/tilt traits changed,
all other traits are tracked
from cue 1
Only pan/tilt traits changed,
all other traits are tracked
from cue 1
Page 161