User Guide
Editing Groups Live
Editing groups live, whether conventional channels or device traits, involves
the following steps:
1. Clear all console output
2. Recall the group
3. Edit the levels or device traits as required
4. Re-record the group.
Recalling Groups
To view a recorded group on stage, press [GROUP] [#] [FULL].
You can assign a level to a group in the command line. Just like
submasters, levels within the group read proportionally to the level
assignment of the group. For example: Group 20 contains channels 1
through 24 at 80%. To assign group 2 to a proportional level of 50% in the
Stage display press: [GROUP] [20] [AT] [50]. Channels 1 - 24 are set at
40% on stage (40% = 50% of 80%).
Device Traits stored in groups do not react to the level of the group.
They are always recalled at the level they were recorded at regardless
of the level of the group.
Editing a channel group live
To edit a group of conventional channels live you basically re-record the
group:
1. Press [STAGE]
2. Press [ENTER] [AT] [ENTER] [CLEAR]
to clear screen (if necessary)
3. Press [GROUP] [44] [FULL]
4. Select channels and set new levels
5. Press [RECORD GROUP] [44]
6. Press [ENTER] [ENTER]
Rev. 1.30.03.07.r1
Chapter 6 Groups
Opens Stage display
All levels from group 44
recalled and captured
Initiates re-record of group
Pressing [ENTER] a second
time overwrites the old group.
Page