Setting Worklight Level; Selecting Dimmer Protocol - Leviton 600 User Manual

User Guide

Setting Worklight level

Depending on the model purchased, the control console has from 1 to 3
connectors on the back panel for the optional gooseneck worklights. This
menu item is used to set the intensity level of the console worklights.
Follow this example to set the worklight intensity to 100:
Procedure:
1. Press [SETUP]
2. Press [12] [ENTER]
3. Enter [100] [ENTER]
4. Press [ENTER]

Selecting Dimmer Protocol

You can select between two different dimmer protocols for the output of
the console: DMX512 (USITT 1990 standard) and CMX (Colortran Multiplex
protocol). You can also select the ColorNet universe output number if the
console is to be connected to a LAN (Local Area Network). The protocols for
Ports A, B, and C are selected from Menu items 13, 14, and 15 respectively.
The console remembers the dimmer protocol setting when you turn the
console off, but not after you do a hard clear. Other conditions under which
protocol may need to be reset include when you update the console to new
software or when the RAM battery is dead.
Follow this example to assign DMX protocol to Port A:
Procedure:
1. Press [SETUP]
2. Press [13] [ENTER]
3. Use the up/down arrow keys
to select "DMX 512"
4. Press [ENTER]
Chapter 14 Alternate Control Interfaces
See
Rev. 1.30.03.07.r1
Chapter 12 System Settings
Notes:
Opens the Setup display
Selects menu item 12:
"Worklight level"
Valid numbers are 0 to 100
Notes:
Opens the Setup display
Selects menu item 13, "Port A"
Valid options are DMX, CMX,
or Universe 1 - 9 (ColorNet)
Confirms selection
for information on ColorNet.
Page 191