Console Operating Modes; Two Scene Mode (All Models Except 600) - Leviton 600 User Manual

Chapter 3 Setting Channel Levels

Console Operating Modes

Two Scene Mode
Scene A
Scene B
Figure 3.4 Two Scene Mode
Two Scene mode is the simplest way to operate the console. It is also a
good way to become comfortable with some of the features if you are a
new user.
When in Two Scene mode, Scene A and Scene B control the
numbers. For example, when using the 24/48 console, Scene A controls
channels 1 - 24 and Scene B also controls channels 1 - 24 (when the A/B
crossfader is at its top position, scene A is active; when it is at its bottom
position, scene B is active). Scenes A and B can then be crossfaded by
using the A/B crossfader. See example procedure on next page.
To set the operating mode to Two-Scene, follow below:
Procedure:
1. Press [SETUP] [21] [ENTER]
2. Use the up/down arrow keys
to select "Two Scene"
Page 36
(All models except Innovator 600)
A/B Crossfader
Notes:
Note that the system default is
"Single Scene".
same
channel
Rev. 1.30.03.07.r1