Chapter 3 Setting Channel Levels
How to set levels with the Trackball
The keypad and trackball can be used together to select and set channel
levels. In this method, the channels are selected with the keypad (as
described in the preceding section) and the levels are set with the trackball.
Follow these example steps to set levels using the keypad and the trackball:
Procedure:
1. Press [STAGE]
2. Press [1]
3. Press [ENTER]
4. Adjust trackball to set channel level
Channel levels can also be selected and set by only using the trackball. To
use just the trackball, first locate the cursor by moving the trackball. If you
have been selecting channels with the keypad or performing edits to levels,
you may find it necessary to push the [CLEAR] button a few times in order
to regain control of the cursor with the trackball.
Procedure:
1. Press [STAGE]
2. Select a channel with trackball
3. Press and hold the [CHANGE] key
while adjusting levels with trackball
Figure 3.2 Trackball
Page 30
Notes:
Opens Stage display
Notes:
Opens Stage display
Place the cursor directly
beneath
the channel number
Release [CHANGE] key when
done
Trackball
Rev. 1.30.03.07.r1