Hhr Functions - Leviton 600 User Manual

User Guide
The maximum cable length that the console can support for a HHR is
1000 feet, including all connecting cables and permanent wiring.

HHR Functions

When the control console receives a character signal through its Hand Held
Remote port, the console interprets the character signal as if the
corresponding key was pressed on the console in the Stage display.
The Hand Held Remote port receives keystroke codes in particular order to
make up commands to be executed by the console. Generally speaking,
commands at the HHR are made the same way that they are at the console
in the Stage display. All commands must be terminated by the [ENTER]
key, which sends the command to the processor for execution. The
exception to this is single-keystroke commands that do not require
[ENTER] are as follows: [GO], [STOP/REV], [CLEAR].
Hand Held Remote Keys/Functions
HHR
. (decimal)
AND (+)
AT (@)
CLEAR
CUE
DIM
DOWN
ENTER
Rev. 1.30.03.07.r1
Chapter 14 Alternate Control Interfaces
Key Description
Decimal point
Used to create channel lists [#] [+] [#]
Assigns a level in a level
setting command.
@ means "at a level of"
Backspaces through a
partially complete command
Begins a cue editing
command or uses a cue as [ENTER]
a group
Begins Dimmer Check
command
Decrements level of
captured channels
Executes a command or
captures all active channels
under wheel control
Example
[1] [>] [10] [@] [50]
[CUE] [#] [@] [level]
[DIM] [#] [@] [level]
[ENTER]
Page 207