Chapter 3 Setting Channel Levels
How to Set Levels with Channel Faders
(All models except Innovator 600)
Channel levels can be set directly with the channel faders, however, you are
limited to the actual number of physical channel faders on the console. For
example, in the case of the 48/96, this would be 96.
See the following example to use channel faders to set levels:
Procedure:
1. Press [STAGE]
2. Raise channel faders 1 thru 5 to 80%
3. Lower the grand-master to 50%
Channel faders cannot be used to edit levels in a Preview display.
Figure 3.0 Channel Faders
Channel Bump Buttons
Located below each channel fader is a channel bump button. The channel
bump buttons have two modes of operation; when pressed they will either
momentarily bring the channel level to full or toggle the level on/off. For
information on how to set the channel bump button mode, see
System Settings
Page 28
Channel Fader Section
.
Notes:
Opens Stage display
Stage display will show
channel levels.
Channel levels are
proportionally lowered to
40%. (50% of 80 = 40)
Chapter 12
Rev. 1.30.03.07.r1