Installing Console Worklights - Leviton 600 User Manual

Appendix A Installation
Figure A.4 Monitor and Peripheral Device Connections
Monitor Connection: The monitor is supplied with a control cable
terminated in a high-density 15-pin "D" connector. Connect the monitor
control cable to the console connector marked VIDEO 1. The VIDEO 1
connector is a computer industry standard SVGA control connector. You can
secure the connector with a small, flat blade screwdriver, or in some cases,
with built-in hand-screws. If you purchased the second video option and
second monitor, attach it to the connector labeled VIDEO 2.
Peripheral Devices: If desired, peripheral devices may be connected to
the console back panel connectors as follows:
• Printer: Computer industry standard parallel printer connector. Not all
printers will work with the console, see
• Keyboard: Computer industry standard 101 style keyboard.
• MIDI: Industry standard Musical Instrument Digital Interface
• Remote Macros: Accepts Contact closure inputs
• ColorNet: For Remote Video, Network DMX, and network HHR
(not available on all models)
• Hand Held Remote: Accepts model no.7-2021 Hand Held Remote.
(For information on the Hand Held Remote and ColorNet, please see
Chapter 14 Advanced Control Interfaces

Installing Console Worklights

Worklights are optional console accessories. The worklights plug into the 3-
pin XLR style or BNC connectors on the rear of the console. The intensity of
the worklights is set as option #12 on the Setup display. Refer to
Chapter 12 System Settings
Page 222
Chapter 13 Printing
.)
for more information.
.
Rev. 1.30.03.07.r1