Leviton 600 User Manual page 172

Chapter 10 Automated Devices
Devices and Cue Tracking
Cues using automated devices can be created easily by using Tracking as
the cue record mode. Tracking allows you to record a number of sequential
cues and adjust just the traits you want to change for each cue while not
affecting the other traits which track. Refer to
information on Tracking.
The example Tracksheet display below shows how Tracking can be used to
record cues 1 - 3. Only the pan and tilt positions changed in each cue while
the other traits remained the same (tracked). Follow the steps on the next
page as a tutorial to recreate this example.
Figure 10.7 Tracking Device Cues
The trackball can be used while in the Tracksheet display to change
individual trait levels: Position the trackball cursor over a trait then press
and hold the [CHANGE] key while adjusting the level.
The trackball can also be used to change a level into a tracking or non-
tracking level: Position the trackball cursor over a trait then press the
[SELECT] key. Next, use the trackball to highlight "Toggle Tracking"
from the "Choose" popup menu which appears, then press [CHANGE].
Page 160
Chapter 5 Cues
for more
Tracking levels (gray)
Rev. 1.30.03.07.r1